- Made in the USA
- No grinding, lapping or sharpening of any kind.
- Each new insert edge is sharp and ready to use.
- Tool life is 25 - 30 times, even 100 times your expectations with high quality High Speed Steel tools.
- All tools are manufactured to high quality standards. Every holder has an aluminum oxide finish to prevent rust.
- New tool bits, torx screws, and torx wrenches are reasonable and readily available.
- Strong metal shanks, minimize vibration and chatter
A robust and hard working tool with a soft touch for both heavy-duty and delicate work. Available with or without handle. The length of the tool with handle (STHHRCL3H) is 590 mm, the tool without handle (STHHRCL3) is 205 mm long.
Content STHHRCL3H: Cutter 10 mm, toolsupport with handle (total lenght 590 mm, handle 440 mm), Torx - screw and Torx-wrench.
Content STHHRCL3: Cutter 10 mm, toolsupport without handle (total lenght 205 mm), Torx - screw and Torx-wrench.
A new model of hollowing tool after design from Jimmy Clewes. The cutter is set in a machined pocket at approximately 22 degrees. This allows for a more user friendly, less aggressive cut which is great for confidence building! Total length of the tool is 215 mm and comes without handle.
Mate #1 has a small 6mm cup cutter.
Mate #2 has a 8mm cup cutter.
Hunter n°1 Tool
The Hunter n°1 Tool has a 6 mm cutter mounted on a sqaure shaft. this way it is possible to mount it on existing tools such as the Oneway Termite.
Content STH1: Cutter 6 mm, square cutter support 4.8 mm x 4.8 mm x 33 mm with Torx screw and Torx-wrench.
Hunter n°5 Full Swann Neck
The # 5 Full Swan Neck is a larger version of the # 3 tool, measuring about 10" long and with a shaft width of 5/8". This tool is especially useful for turning boxes and the insides of all hollow forms. It is manufactured from the standard # 5 tool, but with the distinctive swan-neck. The tool comes with the #3/5 carbide cutter and wrench.
Hunter n°5 Tool
Content STH5: Cutter 10 mm, toolsupport with handle (total lenght 640 mm, handle 440 mm), Torx - screw and Torx-wrench.
A combination of bowl/spindle gouge with the unique Hunter cutters.
diameter cutter: 6mm
diameter shank: 10mm
total length: 46 cm
diameter cutter: 8mm
diameter shank: 13mm
total length: 59 cm
Designed by Mark St. Leger, noted box maker, and are to be used on vessel’s 3” tall max and smaller.
These tools can be used to rough out hollow forms, but the best use is for finishing and final form shaping as shown on the illustration.
The # 1 Straight tool will clean up the bottom, the # 1 Hook Tool will will clean up the sides and then the hardest cut for any turner is to clean up the shoulder which the # 1 Shoulder or Back tool is designed to reach.